Re:Gecko help

on 2002-09-06 16:10:40 UTC

The motor is a 5 phase , 5 wire ,square style 10 coil, .72 degree.
I have tried the archives . If I get a 5 phase vexta driver can I use
it in conjuction with cncpro and my Gecko drives , say running the
rotary table?
thanks
Mark

Discussion Thread

markpowerplus 2002-09-06 16:10:40 UTC Re:Gecko help Jon Elson 2002-09-06 21:39:54 UTC Re: [CAD_CAM_EDM_DRO] Re:Gecko help Alan Marconett KM6VV 2002-09-07 09:12:53 UTC Re:Gecko help Jon Elson 2002-09-07 22:10:58 UTC Re: [CAD_CAM_EDM_DRO] Re:Gecko help Alan Marconett KM6VV 2002-09-08 13:25:32 UTC Re:Gecko help Jon Elson 2002-09-08 13:57:57 UTC Re: [CAD_CAM_EDM_DRO] Re:Gecko help Alan Marconett KM6VV 2002-09-08 14:06:47 UTC Re:Gecko help turbulatordude 2002-09-09 06:06:38 UTC 5 phase driver ? ( was Re:Gecko help Carey Culpepper 2002-09-09 09:57:17 UTC Re: [CAD_CAM_EDM_DRO] 5 phase driver ? ( was Re:Gecko help Jon Elson 2002-09-09 21:36:07 UTC Re: [CAD_CAM_EDM_DRO] 5 phase driver ? ( was Re:Gecko help turbulatordude 2002-09-10 05:36:39 UTC 5 phase driver ? ( was Re:Gecko help