CAD CAM EDM DRO - Yahoo Group Archive

Re:Gecko help

on 2002-09-08 13:25:32 UTC
Hi Jon,

No such luck here! I did get it moving with my controller, but not as
"correct" as I think it should be. No mention of such a switch in the
Japanese language manual (UDX 5114). If I had a pair, I'd consider
putting THEM on my planned PCB router table. Although NEMA # 34 is a
little bit for it.

Alan KM6VV


Jon Elson wrote:
>
> Alan Marconett KM6VV wrote:
>
> > Hi Mark,
> >
> > You might find that the 5-phase driver takes CW/CCW inputs! And I found
> > them to be a little STRANGE, but then, I don't read Japanese!
>
> The "Super Vexta" driver I have is marked like that, but there is a switch
> you can flip that converts it to step & direction.
>
> Jon

Discussion Thread

markpowerplus 2002-09-06 16:10:40 UTC Re:Gecko help Jon Elson 2002-09-06 21:39:54 UTC Re: [CAD_CAM_EDM_DRO] Re:Gecko help Alan Marconett KM6VV 2002-09-07 09:12:53 UTC Re:Gecko help Jon Elson 2002-09-07 22:10:58 UTC Re: [CAD_CAM_EDM_DRO] Re:Gecko help Alan Marconett KM6VV 2002-09-08 13:25:32 UTC Re:Gecko help Jon Elson 2002-09-08 13:57:57 UTC Re: [CAD_CAM_EDM_DRO] Re:Gecko help Alan Marconett KM6VV 2002-09-08 14:06:47 UTC Re:Gecko help turbulatordude 2002-09-09 06:06:38 UTC 5 phase driver ? ( was Re:Gecko help Carey Culpepper 2002-09-09 09:57:17 UTC Re: [CAD_CAM_EDM_DRO] 5 phase driver ? ( was Re:Gecko help Jon Elson 2002-09-09 21:36:07 UTC Re: [CAD_CAM_EDM_DRO] 5 phase driver ? ( was Re:Gecko help turbulatordude 2002-09-10 05:36:39 UTC 5 phase driver ? ( was Re:Gecko help