CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Re:Gecko help

Posted by Jon Elson
on 2002-09-08 13:57:57 UTC
Alan Marconett KM6VV wrote:

> Hi Jon,
>
> No such luck here! I did get it moving with my controller, but not as
> "correct" as I think it should be. No mention of such a switch in the
> Japanese language manual (UDX 5114). If I had a pair, I'd consider
> putting THEM on my planned PCB router table. Although NEMA # 34 is a
> little bit for it.

Mine is a UDX5128NR. It is a thin black box, and runs off 120 V AC.

Jon

Discussion Thread

markpowerplus 2002-09-06 16:10:40 UTC Re:Gecko help Jon Elson 2002-09-06 21:39:54 UTC Re: [CAD_CAM_EDM_DRO] Re:Gecko help Alan Marconett KM6VV 2002-09-07 09:12:53 UTC Re:Gecko help Jon Elson 2002-09-07 22:10:58 UTC Re: [CAD_CAM_EDM_DRO] Re:Gecko help Alan Marconett KM6VV 2002-09-08 13:25:32 UTC Re:Gecko help Jon Elson 2002-09-08 13:57:57 UTC Re: [CAD_CAM_EDM_DRO] Re:Gecko help Alan Marconett KM6VV 2002-09-08 14:06:47 UTC Re:Gecko help turbulatordude 2002-09-09 06:06:38 UTC 5 phase driver ? ( was Re:Gecko help Carey Culpepper 2002-09-09 09:57:17 UTC Re: [CAD_CAM_EDM_DRO] 5 phase driver ? ( was Re:Gecko help Jon Elson 2002-09-09 21:36:07 UTC Re: [CAD_CAM_EDM_DRO] 5 phase driver ? ( was Re:Gecko help turbulatordude 2002-09-10 05:36:39 UTC 5 phase driver ? ( was Re:Gecko help