Re: Take a look,,, Sprutcam/ Deskproto
Posted by
keongsan
on 2002-09-11 16:23:53 UTC
--- In CAD_CAM_EDM_DRO@y..., "IMService" <imserv@v...> wrote:
recall that Deskproto (sometime ago) had a problem with cutting
vertical wall, which were (then) cut as wall with a slight slant.
From: "vrsculptor" <vrsculptor@...>
Cost is around $2,000 although there is a full student version
available for $650. There is a downloadable demo.
http://www.sprutcam.com/
I think the link should be
http://www.sprutcam.ru
> It can also make slabbing cuts and the Totem pole will slice anWould "slabbing cuts" refer to cutting vertical wall. I seem to
> STL file along a rotational axis with either rings or a spiral cut.
recall that Deskproto (sometime ago) had a problem with cutting
vertical wall, which were (then) cut as wall with a slight slant.
From: "vrsculptor" <vrsculptor@...>
Cost is around $2,000 although there is a full student version
available for $650. There is a downloadable demo.
http://www.sprutcam.com/
I think the link should be
http://www.sprutcam.ru
Discussion Thread
vrsculptor
2002-09-11 08:21:29 UTC
Take a look,,, Sprutcam
allan_reinhard
2002-09-11 09:42:09 UTC
Re: Take a look,,, Sprutcam
Peter
2002-09-11 11:54:47 UTC
Re: [CAD_CAM_EDM_DRO] Re: Take a look,,, Sprutcam
robert weiss
2002-09-11 13:31:07 UTC
RE: [CAD_CAM_EDM_DRO] Re: Take a look,,, Sprutcam
vrsculptor
2002-09-11 14:19:44 UTC
Re: Take a look,,, Sprutcam/ Deskproto
IMService
2002-09-11 15:29:51 UTC
Re: Re: Take a look,,, Sprutcam/ Deskproto
keongsan
2002-09-11 16:23:53 UTC
Re: Take a look,,, Sprutcam/ Deskproto
stevenson_engineers
2002-09-11 17:31:23 UTC
Re: Take a look,,, Sprutcam/ Deskproto
Fred Smith
2002-09-11 20:12:45 UTC
Re: Take a look,,, Sprutcam/ Deskproto
Andrew Werby
2002-09-11 22:10:30 UTC
Re: Take a look,,, Sprutcam/ Deskproto
mrjensan
2002-09-12 05:45:00 UTC
Re: Take a look,,, Sprutcam/ Deskproto
Carol & Jerry Jankura
2002-09-12 10:48:40 UTC
RE: [CAD_CAM_EDM_DRO] Re: Take a look,,, Sprutcam/ Deskproto