Re: EMC Following Error

--- In CAD_CAM_EDM_DRO@y..., "cadcamcenter" <cadcamcenter@y...> wrote:

> --- In CAD_CAM_EDM_DRO@y..., "William Scalione" <wscalione@n...>
>
> > Gecko Drive if you can plug the step multipliers onto the G320's
> and make
> > them into G340's. Set them for 10X and drop your input scale to
> 3,200 steps
> > per inch. I think they are about $25.00 each.
>
> Is it possible to have an external step-multiplier? Say,

incorporated

> into something similar to a parallel port buffer, etc.? Then one

can

> use for either G201 or G320, or any other drives?

Or to somehow incorporate the G320 step-multiplier into a parallel
breakout board/buffer which will then take pulses from the parallel
port, then spit out multiplied pulses into whatever drives including
G201/g320 for better speed?