CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] EMC Following Error

on 2002-09-16 04:17:01 UTC
> > I had already made some pulley blanks so that I could reduce the 32000
steps
> > per inch to 16000. This afternoon I cut the teeth on them.
>
> What did you use for a cutter, homemade, or commercial? If the latter
what
> was your source?

Bill, I used a home made flycutter. Piece of oil hardening steel in the
lathe, turn the profile (carefully) then grind half away, finally harden and
temper. Cuts aluminium well and the result works fine with the MX belts.

Dave.

> thanks,
> bill

Discussion Thread

David Micklethwaite 2002-09-14 16:49:45 UTC EMC Following Error William Scalione 2002-09-14 17:44:19 UTC Re: [CAD_CAM_EDM_DRO] EMC Following Error Tim Goldstein 2002-09-14 19:34:33 UTC RE: [CAD_CAM_EDM_DRO] EMC Following Error cadcamcenter 2002-09-14 20:21:52 UTC Re: EMC Following Error cadcamcenter 2002-09-14 20:32:09 UTC Re: EMC Following Error Jon Elson 2002-09-14 22:28:02 UTC Re: [CAD_CAM_EDM_DRO] EMC Following Error bsptrades 2002-09-15 00:41:02 UTC Re: EMC Following Error David Micklethwaite 2002-09-15 04:16:26 UTC Re: [CAD_CAM_EDM_DRO] EMC Following Error David Micklethwaite 2002-09-15 04:16:29 UTC Re: [CAD_CAM_EDM_DRO] EMC Following Error David Micklethwaite 2002-09-15 04:16:31 UTC Re: [CAD_CAM_EDM_DRO] Re: EMC Following Error wanliker@a... 2002-09-15 09:13:04 UTC Re: [CAD_CAM_EDM_DRO] EMC Following Error William Scalione 2002-09-15 13:25:48 UTC Re: [CAD_CAM_EDM_DRO] EMC Following Error Ray Henry 2002-09-15 17:05:18 UTC Re: RE: EMC Following Error Jon Elson 2002-09-15 22:08:56 UTC Re: [CAD_CAM_EDM_DRO] EMC Following Error David Micklethwaite 2002-09-16 04:17:01 UTC Re: [CAD_CAM_EDM_DRO] EMC Following Error