Re: EMC Following Error
Posted by
cadcamcenter
on 2002-09-14 20:21:52 UTC
--- In CAD_CAM_EDM_DRO@y..., "William Scalione" <wscalione@n...>
into something similar to a parallel port buffer, etc.? Then one can
use for either G201 or G320, or any other drives?
Peter
> Gecko Drive if you can plug the step multipliers onto the G320'sand make
> them into G340's. Set them for 10X and drop your input scale to3,200 steps
> per inch. I think they are about $25.00 each.Is it possible to have an external step-multiplier? Say, incorporated
into something similar to a parallel port buffer, etc.? Then one can
use for either G201 or G320, or any other drives?
Peter
Discussion Thread
David Micklethwaite
2002-09-14 16:49:45 UTC
EMC Following Error
William Scalione
2002-09-14 17:44:19 UTC
Re: [CAD_CAM_EDM_DRO] EMC Following Error
Tim Goldstein
2002-09-14 19:34:33 UTC
RE: [CAD_CAM_EDM_DRO] EMC Following Error
cadcamcenter
2002-09-14 20:21:52 UTC
Re: EMC Following Error
cadcamcenter
2002-09-14 20:32:09 UTC
Re: EMC Following Error
Jon Elson
2002-09-14 22:28:02 UTC
Re: [CAD_CAM_EDM_DRO] EMC Following Error
bsptrades
2002-09-15 00:41:02 UTC
Re: EMC Following Error
David Micklethwaite
2002-09-15 04:16:26 UTC
Re: [CAD_CAM_EDM_DRO] EMC Following Error
David Micklethwaite
2002-09-15 04:16:29 UTC
Re: [CAD_CAM_EDM_DRO] EMC Following Error
David Micklethwaite
2002-09-15 04:16:31 UTC
Re: [CAD_CAM_EDM_DRO] Re: EMC Following Error
wanliker@a...
2002-09-15 09:13:04 UTC
Re: [CAD_CAM_EDM_DRO] EMC Following Error
William Scalione
2002-09-15 13:25:48 UTC
Re: [CAD_CAM_EDM_DRO] EMC Following Error
Ray Henry
2002-09-15 17:05:18 UTC
Re: RE: EMC Following Error
Jon Elson
2002-09-15 22:08:56 UTC
Re: [CAD_CAM_EDM_DRO] EMC Following Error
David Micklethwaite
2002-09-16 04:17:01 UTC
Re: [CAD_CAM_EDM_DRO] EMC Following Error