Re: Re: Re: Re: Re: HARDINGE HNC RETROFIT

Doug

I'm not near one of these right now but I believe the motor power supply
is on the floor of the fridge. There may be a small panel and caps on
the left side. It will say something like 90 volt. You could trace it
back from the two identical axis drive boards. They are about 6" by 14"
with a very large capacitor on the left side. These should be mounted on
the lower right hand side if the fridge.

Ray

>    From: doug king <evelle97530@...>
> Subject: Re: Re: Re: Re: HARDINGE HNC RETROFIT
>>  
> Hi Ray.Are  we talking components attached to the lathe proper,or in
> the "fridge"controller-the big one?Is the motor power supply in the big
> cabinet?Thanks,