Fanuc 6m help
Posted by
gorton22
on 2002-10-09 19:52:07 UTC
Hello everyone: My name is Don Blausey and I joined the group
recently.
I have a gorton mill with a fanuc 6m control on it. I have used this
mill for the past few years in my home shop. While using it a few
weeks ago the control died as it has frequently in the past year. I
would like
to save the drives and the motors and install a new control. I know
that
I will have to change the resolver to encoders. I have learned that
from the many web sites I have viewed in the past few weeks. I have
been following this site and am not sure if I am in the right place.
This machine has a 10" x 50" table on it, and most of the post are for
table top machines. I have checked out camsoft and a few others and
not ready to spend that on this machine. Repairs on old boards are not
cheap either. Has any one else done this or have a sugestion on what
to do. Any help greatly appreciated.
recently.
I have a gorton mill with a fanuc 6m control on it. I have used this
mill for the past few years in my home shop. While using it a few
weeks ago the control died as it has frequently in the past year. I
would like
to save the drives and the motors and install a new control. I know
that
I will have to change the resolver to encoders. I have learned that
from the many web sites I have viewed in the past few weeks. I have
been following this site and am not sure if I am in the right place.
This machine has a 10" x 50" table on it, and most of the post are for
table top machines. I have checked out camsoft and a few others and
not ready to spend that on this machine. Repairs on old boards are not
cheap either. Has any one else done this or have a sugestion on what
to do. Any help greatly appreciated.
Discussion Thread
gorton22
2002-10-09 19:52:07 UTC
Fanuc 6m help
vrsculptor
2002-10-09 20:08:45 UTC
Re: Fanuc 6m help
Rick E
2002-10-09 20:22:57 UTC
Re: [CAD_CAM_EDM_DRO] Fanuc 6m help
Jon Elson
2002-10-10 23:29:52 UTC
Re: Fanuc 6m help
gorton22
2002-10-12 08:40:07 UTC
Re: Fanuc 6m help
skykotechnologies
2002-10-12 13:42:36 UTC
Re: Fanuc 6m help