CAD CAM EDM DRO - Yahoo Group Archive

Re: power supply connection issues/Correction

Posted by dakota8833
on 2002-10-16 20:03:11 UTC
The neutral wire is grounded at the fuse panal. The green wire is
tied
> to neutral buss bar in the fuse panal. Why the green ground,...
safty
> in backups,... and the "only" ground to any exposed metal at your
PS.
> If for some reason the white wire came off and the black live wire
> shorted to the metal case and you touched it ,..... Lots of "ands"
> here. But if the above happens you will malfunction! If you wire
> without a ground the PS needs to be in a insulated case. Take a look
> at the plastic Control Box in Photos Section. I did ground the main
> power trans. Even though the trans came from a 10 amp battery
charger
> with no ground prong. The wall wart isn't grounded.
>
> Frank

Opps.,,, Would not matter if the white wire come off at the PS. AND
DON"T GROUND THE WHITE WIRE AT THE PS !! If you do this and reverse a
two prong cord at the outlet or if your outlet is wired incorrectly,
you will end up with a live case !

Frank

Discussion Thread

jagco1998 2002-10-16 17:13:43 UTC power supply connection issues hllrsr@c... 2002-10-16 17:28:48 UTC Re: [CAD_CAM_EDM_DRO] power supply connection issues Jerry Kimberlin 2002-10-16 17:30:21 UTC Re: [CAD_CAM_EDM_DRO] power supply connection issues Garry & Maxine Foster 2002-10-16 17:45:32 UTC Re: [CAD_CAM_EDM_DRO] power supply connection issues Larry Shull 2002-10-16 17:50:12 UTC Re: [CAD_CAM_EDM_DRO] power supply connection issues jagco1998 2002-10-16 19:01:13 UTC Re: power supply connection issues dakota8833 2002-10-16 19:43:59 UTC Re: power supply connection issues dakota8833 2002-10-16 20:03:11 UTC Re: power supply connection issues/Correction JanRwl@A... 2002-10-16 20:33:49 UTC Re: [CAD_CAM_EDM_DRO] Re: power supply connection issues Jon Elson 2002-10-16 20:36:36 UTC Re: [CAD_CAM_EDM_DRO] power supply connection issues Jon Elson 2002-10-16 20:47:26 UTC Re: [CAD_CAM_EDM_DRO] Re: power supply connection issues Carol & Jerry Jankura 2002-10-16 21:36:43 UTC RE: [CAD_CAM_EDM_DRO] Re: power supply connection issues Marv Frankel 2002-10-16 21:51:16 UTC Re: [CAD_CAM_EDM_DRO] Re: power supply connection issues Raymond Heckert 2002-10-16 21:54:16 UTC Re: [CAD_CAM_EDM_DRO] power supply connection issues wanliker@a... 2002-10-16 22:44:53 UTC Re: [CAD_CAM_EDM_DRO] power supply connection issues Larry Shull 2002-10-16 22:48:19 UTC Re: [CAD_CAM_EDM_DRO] Re: power supply connection issues jagco1998 2002-10-17 07:36:15 UTC Re: power supply connection issues