CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] power supply connection issues

Posted by wanliker@a...
on 2002-10-16 22:44:53 UTC
In a message dated 10/16/2002 6:46:38 PM Mountain Daylight Time,
garry.foster@... writes:


> Neutral and Line..I leave it up to you which is N and which is L.
>

If the line cord goes to either a 2 or a 3 wire plug, the wider/higher of the
two blades on the plug, is defined by code to be the Neutral connection,
hopefully your receptacles are wired correctly, on the receptacle sides,
there are two screws, one silver in color, the other brass, the silver is the
Neutral and should be white, the Brass is the hot wire, normally black in
most houses, but can legally be any color but white. {Exception} being if it
is a switched receptacle and it is a white feeding from the switch, but it
should be marked with black tape. The ground wire of the 3 wire cord will
normally be green or green/yellow.
bill


[Non-text portions of this message have been removed]

Discussion Thread

jagco1998 2002-10-16 17:13:43 UTC power supply connection issues hllrsr@c... 2002-10-16 17:28:48 UTC Re: [CAD_CAM_EDM_DRO] power supply connection issues Jerry Kimberlin 2002-10-16 17:30:21 UTC Re: [CAD_CAM_EDM_DRO] power supply connection issues Garry & Maxine Foster 2002-10-16 17:45:32 UTC Re: [CAD_CAM_EDM_DRO] power supply connection issues Larry Shull 2002-10-16 17:50:12 UTC Re: [CAD_CAM_EDM_DRO] power supply connection issues jagco1998 2002-10-16 19:01:13 UTC Re: power supply connection issues dakota8833 2002-10-16 19:43:59 UTC Re: power supply connection issues dakota8833 2002-10-16 20:03:11 UTC Re: power supply connection issues/Correction JanRwl@A... 2002-10-16 20:33:49 UTC Re: [CAD_CAM_EDM_DRO] Re: power supply connection issues Jon Elson 2002-10-16 20:36:36 UTC Re: [CAD_CAM_EDM_DRO] power supply connection issues Jon Elson 2002-10-16 20:47:26 UTC Re: [CAD_CAM_EDM_DRO] Re: power supply connection issues Carol & Jerry Jankura 2002-10-16 21:36:43 UTC RE: [CAD_CAM_EDM_DRO] Re: power supply connection issues Marv Frankel 2002-10-16 21:51:16 UTC Re: [CAD_CAM_EDM_DRO] Re: power supply connection issues Raymond Heckert 2002-10-16 21:54:16 UTC Re: [CAD_CAM_EDM_DRO] power supply connection issues wanliker@a... 2002-10-16 22:44:53 UTC Re: [CAD_CAM_EDM_DRO] power supply connection issues Larry Shull 2002-10-16 22:48:19 UTC Re: [CAD_CAM_EDM_DRO] Re: power supply connection issues jagco1998 2002-10-17 07:36:15 UTC Re: power supply connection issues