newbie questions on visual mill
Posted by
Steve Ross
on 2002-10-20 09:09:30 UTC
Hello
I just started trying to use visual mill and have 4 question. Any help
would be appreciated.
1. In the help index when you click on create it says there is no page to
be found. Is this a bug?
2. Can you resize your cad project bigger or smaller for post processing in
visual mill.
3. How can I switch over to millimeters from inchs or is that again specfic
to the cad model.
4. how does the different operations i.e roughing, finishing work in the
post processor. I have a taig mill which does not have a tool changer, does
each operation stop and wait for an operator command or is it continuious.
and you have to break up the cam operations.
Thanks
Steve Ross
I just started trying to use visual mill and have 4 question. Any help
would be appreciated.
1. In the help index when you click on create it says there is no page to
be found. Is this a bug?
2. Can you resize your cad project bigger or smaller for post processing in
visual mill.
3. How can I switch over to millimeters from inchs or is that again specfic
to the cad model.
4. how does the different operations i.e roughing, finishing work in the
post processor. I have a taig mill which does not have a tool changer, does
each operation stop and wait for an operator command or is it continuious.
and you have to break up the cam operations.
Thanks
Steve Ross
Discussion Thread
djld98370
2002-10-20 08:53:31 UTC
is any one using rutex plasma softwear or drives?
Steve Ross
2002-10-20 09:09:19 UTC
newbie questions on visual mill
Steve Ross
2002-10-20 09:09:30 UTC
newbie questions on visual mill
Tim Goldstein
2002-10-20 10:02:22 UTC
RE: [CAD_CAM_EDM_DRO] newbie questions on visual mill
Peter
2002-10-20 11:58:08 UTC
Re: [CAD_CAM_EDM_DRO] newbie questions on visual mill