Re: Ideas for matching drives on a YY axis design?
Posted by
caudlet
on 2002-10-23 05:06:12 UTC
--- In CAD_CAM_EDM_DRO@y..., Jim Brown <jagco1998@y...> wrote:
axis, and drive it from the center with the ballscrew/leadscrew?
use it for both router and plasma cutting. I am designing a quick
change head for the Z axis to take either tool. You need an open
table for plasma cutting. Nothing but a water tank under the cutting
area. I also wanted the additional power of twin screws since the
gantry weights over 100lbs. Moving that much mass at 120IPM takes
some power.
>it will have less of a chance of binding when traversing in the x
> Just curious............
> Why cant you just space out the linear bearings on the z/y axis' so
axis, and drive it from the center with the ballscrew/leadscrew?
> I realize that this will be a big feat to perform, being the widthof the gantry. But It can be done, cant it?
>Jim: The machine is designed to have a convertable table so I can
> Regards,
> Jim
use it for both router and plasma cutting. I am designing a quick
change head for the Z axis to take either tool. You need an open
table for plasma cutting. Nothing but a water tank under the cutting
area. I also wanted the additional power of twin screws since the
gantry weights over 100lbs. Moving that much mass at 120IPM takes
some power.
Discussion Thread
caudlet
2002-10-22 10:44:45 UTC
Ideas for matching drives on a YY axis design?
deanc500
2002-10-22 11:02:53 UTC
Re: Ideas for matching drives on a YY axis design?
Jim Brown
2002-10-22 13:58:29 UTC
Re: [CAD_CAM_EDM_DRO] Ideas for matching drives on a YY axis design?
Doug Harrison
2002-10-22 17:28:00 UTC
Re: [CAD_CAM_EDM_DRO] Ideas for matching drives on a YY axis design?
dakota8833
2002-10-22 19:28:49 UTC
Re: Ideas for matching drives on a YY axis design?
Gene
2002-10-23 00:05:09 UTC
Re: [CAD_CAM_EDM_DRO] Re: Ideas for matching drives on a YY axis design?
caudlet
2002-10-23 05:06:12 UTC
Re: Ideas for matching drives on a YY axis design?
turbulatordude
2002-10-23 08:23:06 UTC
25Khz glitch ? (was Re: Ideas for matching drives on a YY axis design?
deanc500
2002-10-23 17:23:38 UTC
25Khz glitch ? (was Re: Ideas for matching drives on a YY axis design?
JJ
2002-10-24 05:35:58 UTC
RE: [CAD_CAM_EDM_DRO] Re: Ideas for matching drives on a YY axis design?