RE: [CAD_CAM_EDM_DRO] Re: Stewart Platforms...
Posted by
Askew, Jason
on 2002-11-12 11:27:05 UTC
>-----Original Message-----To Carl --> I'm interested in this, also... (what type of software you
>From: Frank de Beer [mailto:f.debeer@...]
>Sent: Monday, November 11, 2002 2:54 PM
>To: CAD_CAM_EDM_DRO@yahoogroups.com
>Subject: RE: [CAD_CAM_EDM_DRO] Re: Stewart Platforms...
>
>
>Hi Carl,
>
>What program do you use for controlling your Stewart platform?
>
>Frank de Beer
>
use).
Someone said that when using EMC to control a stewart platform, it only does
XYZ, and not pitch, yaw, etc...
Can anyone confirm this?
Thanks, Jason
Discussion Thread
killthiskid
2002-11-08 23:09:06 UTC
Stewart Platforms...
dakota8833
2002-11-09 05:22:18 UTC
Re: Stewart Platforms...
Ray Henry
2002-11-09 06:21:52 UTC
Re: Stewart Platforms...
Marv Frankel
2002-11-09 07:57:40 UTC
Re: [CAD_CAM_EDM_DRO] Re: Stewart Platforms...
Bob Simon
2002-11-09 08:02:01 UTC
Re: [CAD_CAM_EDM_DRO] Re: Stewart Platforms...
Bob Simon
2002-11-10 09:16:20 UTC
Is EMC used for lathes?
Tim Goldstein
2002-11-10 09:34:12 UTC
RE: [CAD_CAM_EDM_DRO] Is EMC used for lathes?
Bob Simon
2002-11-10 12:18:24 UTC
RE: [CAD_CAM_EDM_DRO] Is EMC used for lathes?
Askew, Jason
2002-11-10 19:38:10 UTC
RE: [CAD_CAM_EDM_DRO] Re: Stewart Platforms...
Ray Henry
2002-11-11 06:04:48 UTC
Re: RE: Re: Stewart Platforms...
Carl Mikkelsen, Oasis
2002-11-11 06:30:38 UTC
Re: [CAD_CAM_EDM_DRO] Re: Stewart Platforms...
Bob Simon
2002-11-11 13:42:06 UTC
DOS networking
Frank de Beer
2002-11-11 13:51:20 UTC
RE: [CAD_CAM_EDM_DRO] Re: Stewart Platforms...
Askew, Jason
2002-11-12 11:27:05 UTC
RE: [CAD_CAM_EDM_DRO] Re: Stewart Platforms...
Carl Mikkelsen, Oasis
2002-11-12 15:21:33 UTC
RE: [CAD_CAM_EDM_DRO] Re: Stewart Platforms...