CAD CAM EDM DRO - Yahoo Group Archive

stepper controller - help

Posted by Boris Maraz
on 2002-11-16 04:57:10 UTC
Hello everyone!



I have powermax II steppers.

powermax II 1.8° step

model: m22nsxb-jds-ns-02

Vs (dc) 65V

Is (dc) 2.3 A bipolar series

Po 104W

8 wires

torque 253 oz-in



http://www.pacsci.com/products/step_motors/powermaxproducts.html



What kind of controller and power supply is needed for get best of this stepper? Is it possible to make at home such controller? I know that is good to have multiple voltage power supply, so I guess I must have around 140V power supply. But I don't know any driver chips similar l298 that can handle that much voltage.



Any advice?



Boris


[Non-text portions of this message have been removed]

Discussion Thread

Boris Maraz 2002-11-16 04:57:10 UTC stepper controller - help Dan Mauch 2002-11-16 06:37:24 UTC RE: [CAD_CAM_EDM_DRO] stepper controller - help jeffalanp 2002-11-16 08:35:19 UTC Re: stepper controller - help JanRwl@A... 2002-11-16 10:23:58 UTC Re: [CAD_CAM_EDM_DRO] stepper controller - help Tom de Witt 2002-11-16 11:52:40 UTC RE: [CAD_CAM_EDM_DRO] stepper controller - help vrsculptor 2002-11-16 12:19:19 UTC Re: stepper controller - help William Scalione 2002-11-16 17:59:57 UTC Re: [CAD_CAM_EDM_DRO] stepper controller - help John Johnson 2002-11-17 09:09:57 UTC Re: [CAD_CAM_EDM_DRO] stepper controller - help foxwhole2000 2002-12-06 03:15:09 UTC Re: stepper controller - help jeffalanp 2002-12-06 11:32:36 UTC Re: stepper controller - help jagco1998 2002-12-06 15:54:23 UTC Re: stepper controller - help George Erhart 2002-12-06 16:15:28 UTC Re: [CAD_CAM_EDM_DRO] Re: stepper controller - help jeffalanp <xylotex@h... 2002-12-06 16:19:37 UTC Re: stepper controller - help George Erhart 2002-12-06 16:47:47 UTC Re: [CAD_CAM_EDM_DRO] Re: stepper controller - help foxwhole2000 <foxwhole2000@y... 2002-12-06 19:27:45 UTC Re: stepper controller - help jeffalanp <xylotex@h... 2002-12-06 20:24:59 UTC Re: stepper controller - help Brian 2002-12-07 11:01:41 UTC Re: [CAD_CAM_EDM_DRO] Re: stepper controller - help George Erhart 2002-12-07 12:32:18 UTC Re: [CAD_CAM_EDM_DRO] Re: stepper controller - help Brian 2002-12-07 14:32:06 UTC Re: [CAD_CAM_EDM_DRO] Re: stepper controller - help