Windows Step/Dir driver for coordinate measurements
Posted by
Egroupscdh (E-mail)
on 2002-11-18 19:13:32 UTC
Having recently purchased Dolphin CAD/CAM I have been thinking about its
ability to run VB add-ins.
A demo shipped with Dolphin shows a VB macro in Excel that takes Excel data
and draws a cam profile in PartMaster CAD. I have been thinking that if I
could output step/direction pulses to my Ahha RC-500 stepper driver from VB
and accept a 'contact' input I could digitize contours, etc. using my mill.
I know that I can do this with Ahha Artisan (DOS based) but using VB would
allow me to load the data directly into a drawing for manipulation into a
new part drawing and then to PartMaster CAM to produce the part.
So: Anyone know of a simple parallel port driver that is accessible from VB
that supports both input and output?
Cheers,
Chuck Hackett
Omaha, Nebraska, USA
ability to run VB add-ins.
A demo shipped with Dolphin shows a VB macro in Excel that takes Excel data
and draws a cam profile in PartMaster CAD. I have been thinking that if I
could output step/direction pulses to my Ahha RC-500 stepper driver from VB
and accept a 'contact' input I could digitize contours, etc. using my mill.
I know that I can do this with Ahha Artisan (DOS based) but using VB would
allow me to load the data directly into a drawing for manipulation into a
new part drawing and then to PartMaster CAM to produce the part.
So: Anyone know of a simple parallel port driver that is accessible from VB
that supports both input and output?
Cheers,
Chuck Hackett
Omaha, Nebraska, USA
Discussion Thread
Egroupscdh (E-mail)
2002-11-18 19:13:32 UTC
Windows Step/Dir driver for coordinate measurements
Bryan Mumford
2002-11-18 19:27:00 UTC
Re: [CAD_CAM_EDM_DRO] Windows Step/Dir driver for coordinate measurements
Egroupscdh (E-mail)
2002-11-18 21:18:11 UTC
RE: [CAD_CAM_EDM_DRO] Windows Step/Dir driver for coordinate measurements
glee@i...
2002-11-18 21:30:42 UTC
Re: [CAD_CAM_EDM_DRO] Windows Step/Dir driver for coordinate measurements
Bryan Mumford
2002-11-18 21:58:48 UTC
RE: [CAD_CAM_EDM_DRO] Windows Step/Dir driver for coordinate measurements
Tim Goldstein
2002-11-18 22:06:41 UTC
RE: [CAD_CAM_EDM_DRO] Windows Step/Dir driver for coordinate measurements
jeffalanp
2002-11-18 22:09:55 UTC
Re: Windows Step/Dir driver for coordinate measurements
Carol & Jerry Jankura
2002-11-19 06:51:06 UTC
RE: [CAD_CAM_EDM_DRO] Windows Step/Dir driver for coordinate measurements
Egroupscdh (E-mail)
2002-11-20 09:04:47 UTC
RE: [CAD_CAM_EDM_DRO] Windows Step/Dir driver for coordinate measurements