CAD CAM EDM DRO - Yahoo Group Archive

Re: Windows Step/Dir driver for coordinate measurements

Posted by jeffalanp
on 2002-11-18 22:09:55 UTC
Hello Chuck,

Go to:

http://www.lvr.com/parport.htm

then search for

Input32.zip

and find the second interation on the page. It's freeware.
Download the file and extract it. I have used the version that comes
with the author's book, and it works well from a VB program.

There's also a 16-bit version if you need that.

Jeff

--- In CAD_CAM_EDM_DRO@y..., "Egroupscdh \(E-mail\)"
<egroupscdh@W...> wrote:
> Having recently purchased Dolphin CAD/CAM I have been thinking
about its
> ability to run VB add-ins.
>
> A demo shipped with Dolphin shows a VB macro in Excel that takes
Excel data
> and draws a cam profile in PartMaster CAD. I have been thinking
that if I
> could output step/direction pulses to my Ahha RC-500 stepper driver
from VB
> and accept a 'contact' input I could digitize contours, etc. using
my mill.
>
> I know that I can do this with Ahha Artisan (DOS based) but using
VB would
> allow me to load the data directly into a drawing for manipulation
into a
> new part drawing and then to PartMaster CAM to produce the part.
>
> So: Anyone know of a simple parallel port driver that is accessible
from VB
> that supports both input and output?
>
> Cheers,
>
> Chuck Hackett
> Omaha, Nebraska, USA

Discussion Thread

Egroupscdh (E-mail) 2002-11-18 19:13:32 UTC Windows Step/Dir driver for coordinate measurements Bryan Mumford 2002-11-18 19:27:00 UTC Re: [CAD_CAM_EDM_DRO] Windows Step/Dir driver for coordinate measurements Egroupscdh (E-mail) 2002-11-18 21:18:11 UTC RE: [CAD_CAM_EDM_DRO] Windows Step/Dir driver for coordinate measurements glee@i... 2002-11-18 21:30:42 UTC Re: [CAD_CAM_EDM_DRO] Windows Step/Dir driver for coordinate measurements Bryan Mumford 2002-11-18 21:58:48 UTC RE: [CAD_CAM_EDM_DRO] Windows Step/Dir driver for coordinate measurements Tim Goldstein 2002-11-18 22:06:41 UTC RE: [CAD_CAM_EDM_DRO] Windows Step/Dir driver for coordinate measurements jeffalanp 2002-11-18 22:09:55 UTC Re: Windows Step/Dir driver for coordinate measurements Carol & Jerry Jankura 2002-11-19 06:51:06 UTC RE: [CAD_CAM_EDM_DRO] Windows Step/Dir driver for coordinate measurements Egroupscdh (E-mail) 2002-11-20 09:04:47 UTC RE: [CAD_CAM_EDM_DRO] Windows Step/Dir driver for coordinate measurements