Re: CAD Question
Posted by
Charles Gallo
on 2000-02-11 20:42:10 UTC
At 09:55 PM 2000-02-11 -0800, you wrote:
Thanks for that hint - I'll still wait till Monday. I have ISDN
right now, which isn't bad at 115 kbps (I'm doing DOV so I don't get hit
for .01/minute/B Channel - that's why 115, not 128), but still, figure that
13 meg would take 21 minutes (figure 10k bytes/sec). Now Monday I get ADSL
(YEAH) so I should get 648kbps, so lets figure 60k Bytes/sec - a 3-4 minute
download - much more reasonable
Charlie
>From: "Steve Carlisle" <quatsein@...>Steve,
>
>Charles, the manual is in the download, even though
>they list it seperatly. Genuine Autocad users have
>comented that it is very good. I cannot verify that
>because I am a beginner CAD user.
>
>Steve
Thanks for that hint - I'll still wait till Monday. I have ISDN
right now, which isn't bad at 115 kbps (I'm doing DOV so I don't get hit
for .01/minute/B Channel - that's why 115, not 128), but still, figure that
13 meg would take 21 minutes (figure 10k bytes/sec). Now Monday I get ADSL
(YEAH) so I should get 648kbps, so lets figure 60k Bytes/sec - a 3-4 minute
download - much more reasonable
Charlie
Discussion Thread
Charles Gallo
2000-02-11 19:35:08 UTC
CAD Question
hansw
2000-02-11 19:52:00 UTC
Re: CAD Question
Steve Carlisle
2000-02-11 21:17:04 UTC
Re: CAD Question
Charles Gallo
2000-02-11 20:15:52 UTC
Re: CAD Question
Steve Carlisle
2000-02-11 21:55:41 UTC
Re: CAD Question
Charles Gallo
2000-02-11 20:42:10 UTC
Re: CAD Question
Jon Elson
2000-02-11 22:17:02 UTC
Re: CAD Question
Matt Shaver
2000-02-12 01:19:42 UTC
Re: CAD Question
PTENGIN@a...
2000-02-12 01:22:03 UTC
Re: CAD Question
Greg Nuspel
2000-02-12 04:03:28 UTC
Re: CAD Question
Matt Shaver
2000-02-12 09:18:09 UTC
Re: CAD Question
Charles Hopkins
2000-02-12 09:17:47 UTC
RE: CAD Question
Ian Wright
2000-02-12 09:35:57 UTC
Re: CAD Question
WAnliker@a...
2000-02-12 09:58:03 UTC
Re: CAD Question
Bob Campbell
2000-02-12 12:46:18 UTC
Re: CAD Question
Fred Smith
2000-02-12 11:04:51 UTC
Re: CAD Question
hansw
2000-02-23 19:08:07 UTC
Re: CAD Question
wanliker@a...
2000-02-23 20:48:26 UTC
Re: CAD Question