Re: CAD Question

Bill,

If you are cutting out flat parts, all you need is a 2D drawing of the
part. In the cam section, you will need to set the depth of the part that
you are going to cut out.

Bob Campbell

----- Original Message -----
From: <WAnliker@...>
To: <CAD_CAM_EDM_DRO@onelist.com>
Sent: Saturday, February 12, 2000 9:58 AM
Subject: Re: [CAD_CAM_EDM_DRO] CAD Question


> From: WAnliker@...
>
> Exactly what do I need to draw for making CAM files? Does it have to be a
3D
> program, or just the different views? This is one subject that I have
never
> seen explained or discussed. Looks like another learning challenge for
one
> who sketches on napkins.
> bill
>
> --------------------------- ONElist Sponsor ----------------------------
>
> Get what you deserve with NextCard Visa. Rates as low as 2.9 percent
> Intro or 9.9 percent Fixed APR, online balance transfers, Rewards
> Points, no hidden fees, and much more! Get NextCard today and get the
> credit you deserve! Apply now! Get your NextCard Visa at
> <a href=" http://clickme.onelist.com/ad/NextcardCreative2SR ">Click
Here</a>
>
> ------------------------------------------------------------------------
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems in the above catagories.
> To Unsubscribe, read archives, change to or from digest.
> Go to: http://www.onelist.com/isregistered.cgi
> Log on, and you will go to Member Center, and you can make changes there.
> For the FAQ, go to http://www.ktmarketing.com/faq.html
> bill,
> List Manager