CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Re: Need Bridgeport Servo - read in PLEASE

Posted by Myron Cherry
on 2002-12-29 21:56:09 UTC
When using thermosetting epoxy, you need to heat the metal where you're
trying to bond - otherwise the metal conducts the heat (from the needed
exothermic reaction) away, and the glue never gets hot enough to really set
up. How hot to heat it? hot enough that you can't touch it.
Hope this helps.
Myron Cherry

----- Original Message -----
From: <cclough@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Sunday, December 29, 2002 9:05 PM
Subject: [CAD_CAM_EDM_DRO] Re: Need Bridgeport Servo - read in PLEASE


> Tim,
>
> You think he used hi-temp epoxy? I tried JB Weld on an older one I
> had that was shot and that didn't work out.
>
> What do you suggest I hold it in place with?
>
> Hopefully the magnet isn't in two pieces... suppose I can put the two
> together somehow.
>
> -Chris
>
> --- In CAD_CAM_EDM_DRO@yahoogroups.com, "Tim Goldstein" <timg@k...>
> wrote:
> > There was another list member that had a servo with a magnet that
> came
> > loose. If I remember correctly he glued it back into place with some
> > high temp epoxy and it worked just fine.
> >
> > Tim
>
>

Discussion Thread

xtecheng <cclough@x... 2002-12-29 19:56:49 UTC Need Bridgeport Servo - read in PLEASE Tim Goldstein 2002-12-29 20:01:57 UTC RE: [CAD_CAM_EDM_DRO] Need Bridgeport Servo - read in PLEASE xtecheng <cclough@x... 2002-12-29 20:05:12 UTC Re: Need Bridgeport Servo - read in PLEASE Jerry Kimberlin 2002-12-29 20:56:25 UTC Re: [CAD_CAM_EDM_DRO] Need Bridgeport Servo - read in PLEASE Myron Cherry 2002-12-29 21:56:09 UTC Re: [CAD_CAM_EDM_DRO] Re: Need Bridgeport Servo - read in PLEASE xtecheng <cclough@x... 2002-12-29 21:58:59 UTC Re: Need Bridgeport Servo - read in PLEASE Myron Cherry 2002-12-30 01:01:03 UTC Re: [CAD_CAM_EDM_DRO] Re: Need Bridgeport Servo - read in PLEASE wdyasq <rgbrown@i... 2002-12-30 06:14:36 UTC Re: Need Bridgeport Servo - read in PLEASE Jon Elson 2002-12-30 10:09:37 UTC Re: [CAD_CAM_EDM_DRO] Re: Need Bridgeport Servo - read in PLEASE xtecheng <cclough@x... 2002-12-30 10:26:30 UTC Re: Need Bridgeport Servo - read in PLEASE xtecheng <cclough@x... 2002-12-30 15:41:47 UTC Re: Need Bridgeport Servo - read in PLEASE