CAD CAM EDM DRO - Yahoo Group Archive

Re: Need Bridgeport Servo - read in PLEASE

on 2002-12-30 10:26:30 UTC
Jon,

After playing with it a little without the epoxy put on, it seems
like it's going to go back in place without a problem. There is some
remaning magnet structure on the casing and it naturally goes back
into position.

-Chris

--- In CAD_CAM_EDM_DRO@yahoogroups.com, Jon Elson <elson@p...> wrote:
>
>
> xtecheng wrote:
>
> >Tim,
> >
> >You think he used hi-temp epoxy? I tried JB Weld on an older one I
> >had that was shot and that didn't work out.
> >
> >What do you suggest I hold it in place with?
> >
> >
> How about a balloon, or a piece of inner tube from a bike?
>
> Make sure the magnet is in VERY close contact to the metal case, as
that
> is a closed magnetic
> path.
>
> Jon

Discussion Thread

xtecheng <cclough@x... 2002-12-29 19:56:49 UTC Need Bridgeport Servo - read in PLEASE Tim Goldstein 2002-12-29 20:01:57 UTC RE: [CAD_CAM_EDM_DRO] Need Bridgeport Servo - read in PLEASE xtecheng <cclough@x... 2002-12-29 20:05:12 UTC Re: Need Bridgeport Servo - read in PLEASE Jerry Kimberlin 2002-12-29 20:56:25 UTC Re: [CAD_CAM_EDM_DRO] Need Bridgeport Servo - read in PLEASE Myron Cherry 2002-12-29 21:56:09 UTC Re: [CAD_CAM_EDM_DRO] Re: Need Bridgeport Servo - read in PLEASE xtecheng <cclough@x... 2002-12-29 21:58:59 UTC Re: Need Bridgeport Servo - read in PLEASE Myron Cherry 2002-12-30 01:01:03 UTC Re: [CAD_CAM_EDM_DRO] Re: Need Bridgeport Servo - read in PLEASE wdyasq <rgbrown@i... 2002-12-30 06:14:36 UTC Re: Need Bridgeport Servo - read in PLEASE Jon Elson 2002-12-30 10:09:37 UTC Re: [CAD_CAM_EDM_DRO] Re: Need Bridgeport Servo - read in PLEASE xtecheng <cclough@x... 2002-12-30 10:26:30 UTC Re: Need Bridgeport Servo - read in PLEASE xtecheng <cclough@x... 2002-12-30 15:41:47 UTC Re: Need Bridgeport Servo - read in PLEASE