Fuse Ratings for Drive protection
Posted by
jeffalanp <xylotex@h...
on 2003-01-01 10:07:21 UTC
Hi All,
Thanks for all the help on Three Phase etc. I have a new question
regarding protecting motor drives with fuses (stepper or servo). How
does one decide on the proper rating for a fuse? (max current then up
to next standard fuse level)? How does one figure in the voltage
rating of the fuse along with the amp rating of the fuse, i.e. if I
have a max of 3.5Amps at 24-28 Volts, what size fuse should I use?
I'll give "Thanks in Advance" now so I don't clutter up the
archives with a separate thanks in the future.
Jeff
http://www.xylotex.com
Thanks for all the help on Three Phase etc. I have a new question
regarding protecting motor drives with fuses (stepper or servo). How
does one decide on the proper rating for a fuse? (max current then up
to next standard fuse level)? How does one figure in the voltage
rating of the fuse along with the amp rating of the fuse, i.e. if I
have a max of 3.5Amps at 24-28 Volts, what size fuse should I use?
I'll give "Thanks in Advance" now so I don't clutter up the
archives with a separate thanks in the future.
Jeff
http://www.xylotex.com
Discussion Thread
jeffalanp <xylotex@h...
2003-01-01 10:07:21 UTC
Fuse Ratings for Drive protection
Peter Seddon
2003-01-02 09:53:09 UTC
Re: [CAD_CAM_EDM_DRO] Fuse Ratings for Drive protection
echnidna <echnidna@y...
2003-01-02 09:57:19 UTC
Re: Fuse Ratings for Drive protection