Re: spindle motor connections
Posted by
mayfieldtm <mayfiet@i...
on 2003-01-09 15:50:05 UTC
Mr. Rowland is correct, NO "standards".
Probably best to visit your local motor rewind shop with a song or $5
or a box of donuts.
They would probably be more than happy to help.
Also... Keep your 3 phase if possible, much better.
Use a "Variable Frequency Drive" to convert to 3 phase, if you can
afford the couple of hundred bucks.
Some people on this list claim to be very happy with them.
Tom M.
Probably best to visit your local motor rewind shop with a song or $5
or a box of donuts.
They would probably be more than happy to help.
Also... Keep your 3 phase if possible, much better.
Use a "Variable Frequency Drive" to convert to 3 phase, if you can
afford the couple of hundred bucks.
Some people on this list claim to be very happy with them.
Tom M.
--- In CAD_CAM_EDM_DRO@yahoogroups.com, JanRwl@A... wrote:
> know that there are VARIOUS connections for single-phase "tool
motors",
> depending on make, and there seems to be NO "standard" for the
terminal or
> wire designations, the way the "centrifugal starter-switch" works,
if any,
> whether there are TWO capacitors or only one, etc.
Discussion Thread
bondeoca <rick@q...
2003-01-09 02:21:11 UTC
spindle motor connections
JanRwl@A...
2003-01-09 14:14:28 UTC
Re: [CAD_CAM_EDM_DRO] spindle motor connections
mayfieldtm <mayfiet@i...
2003-01-09 15:50:05 UTC
Re: spindle motor connections
James Owens
2003-01-09 18:00:28 UTC
Re: [CAD_CAM_EDM_DRO] Re: spindle motor connections