Re: [CAD_CAM_EDM_DRO] Controller Question

Hi Bob,

Looks like you'd have to write your own software, or use their demo
software. It's serial interface is not a standard, and supported by no
one I know of.

I have seen their earlier two axis parallel board. It was 4-phase, low
power. TurboCNC could be set up to drive it.

Alan KM6VV


"badat53 " wrote:

>
> OK a Newbie here needs to know if this controller board will work
> with all the free software and sharewhare programs that use a parallel
> port setup. For the price it seems like a good deal for the newbie. I
> quess what I want to know is can I use this board and use all the
> free software out there, seems most controllers use the paraller port.
> Thank you all for your answers to my questions.
> Bob Douglass
>
> http://www.steppercontrol.com/s100.html
>