Re: NEW member Suitable conversions?
Posted by
Tim Goldstein
on 2000-02-16 11:52:14 UTC
I am running the lathe portion of my 3 in 1 using EMC and it works fine. I
modified my post in my CAM program to give out X & Y in the mill mode
instead of the norm so that I would not have to switch the motor connection
when I am working in mill mode. If I was using a dedicated lathe that would
not be needed.
Tim
[Denver, CO]
modified my post in my CAM program to give out X & Y in the mill mode
instead of the norm so that I would not have to switch the motor connection
when I am working in mill mode. If I was using a dedicated lathe that would
not be needed.
Tim
[Denver, CO]
Discussion Thread
D.F.S.
2000-02-16 11:31:39 UTC
Re: NEW member Suitable conversions?
Tim Goldstein
2000-02-16 11:52:14 UTC
Re: NEW member Suitable conversions?
Jon Elson
2000-02-16 21:32:02 UTC
Re: NEW member Suitable conversions?
D.F.S.
2000-02-17 08:50:01 UTC
Re: NEW member Suitable conversions?
Matt Shaver
2000-02-17 11:35:58 UTC
Re: NEW member Suitable conversions?
D.F.S.
2000-02-17 13:18:29 UTC
Re: NEW member Suitable conversions?
Fred Smith
2000-02-17 14:21:45 UTC
Re: NEW member Suitable conversions?
Paul Corner
2000-02-17 13:53:38 UTC
Re: NEW member Suitable conversions?
Matt Shaver
2000-02-17 15:08:24 UTC
Re: NEW member Suitable conversions?
Tim Goldstein
2000-02-17 15:48:04 UTC
Re: NEW member Suitable conversions?
Fred Smith
2000-02-17 16:22:43 UTC
Re: NEW member Suitable conversions?
PTENGIN@a...
2000-02-17 18:29:43 UTC
Re: NEW member Suitable conversions?
D.F.S.
2000-02-18 09:43:06 UTC
Re: NEW member Suitable conversions?
Darrell
2000-02-18 13:04:24 UTC
Re: NEW member Suitable conversions?
D.F.S.
2000-02-18 14:19:41 UTC
Re: NEW member Suitable conversions?
Darrell
2000-02-18 16:05:58 UTC
Re: NEW member Suitable conversions?
paul@A...
2000-02-18 16:05:58 UTC
Re: NEW member Suitable conversions?
Jon Elson
2000-02-18 21:22:35 UTC
Re: NEW member Suitable conversions?
Darrell
2000-02-18 22:18:48 UTC
Re: NEW member Suitable conversions?