Re: stepper motors missing steps
Posted by
jeffalanp <xylotex@h...
on 2003-01-14 15:16:57 UTC
Hi,
What voltage are the motors rated at. What amperage are they
rated at. What kind of stepper drive are you using, what is your
motor power supply voltage, what is your acceleration rate in
TurboCNC, and finally what is you max speed rate in the TurboCNC
parameters? A little more info might be helpful in trying to resolve
your problem.
Jeff
http://www.xylotex.com
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "dvls333 <dvls333@y...>"
<dvls333@y...> wrote:
What voltage are the motors rated at. What amperage are they
rated at. What kind of stepper drive are you using, what is your
motor power supply voltage, what is your acceleration rate in
TurboCNC, and finally what is you max speed rate in the TurboCNC
parameters? A little more info might be helpful in trying to resolve
your problem.
Jeff
http://www.xylotex.com
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "dvls333 <dvls333@y...>"
<dvls333@y...> wrote:
> Recently i have found a text about using the controller of a disksome
> drive and use the included stepper motor from the parallel port
> I connect everything (i have 2 5,25" teac drives) first i tried the
> mastercontrol ez cnc free software but all i get is some jerky
> movement (just by opening the program) and vibration,then i tried
> turbocnc there everything seems to work fine i jog them cw ccw no
> problem until i realized that if i use the go to (g) command to
> point and then return to the original position ther some stepsto
> missing if sent it to some distance it rotates well for two rounds
> then vibrate loose some steps and then for the last rounds it looks
> ok,also if run a dnc file that after a few small movements return
> the original point, but it never returns.
> Please help, somebody, this is my first try i want to build an
> engraver.
Discussion Thread
dvls333 <dvls333@y...
2003-01-14 14:35:58 UTC
stepper motors missing steps
jeffalanp <xylotex@h...
2003-01-14 15:16:57 UTC
Re: stepper motors missing steps
Jon Elson
2003-01-14 18:37:13 UTC
Re: [CAD_CAM_EDM_DRO] stepper motors missing steps
Vajk Fekete
2003-01-15 01:43:24 UTC
Re: [CAD_CAM_EDM_DRO] stepper motors missing steps