CAD CAM EDM DRO - Yahoo Group Archive

Re: Re: EMC question

Posted by Ray Henry
on 2003-01-22 10:43:43 UTC
>    From: "krnldmp <krnldmp@...>" <krnldmp@...>
> Subject: Re: EMC question
>
> > Yes, hardware can make a difference but it should not make to much
> > of a difference.  
>
> I really didn't think so. For one thing, I'm not actually using that
> much hardware, as you'll see...

> Now Via/Cyrix processors are the most common in my basement.
>
> I accidentally burned my last one of those up a couple years ago. The
> remaining recyclable machine has an AMD 200 in it, and that's what I'm
> running lately.

The 800-966 MHz Via/Cyrix procs are coming back with a vengence. Most
are surface mount on little motherboards that are stuffed into tiny
boxes. WalMart.com had a small 800 MHz desktop for $199 before the new
year. This included 128 meg, cdrom, kbd, mouse, speakers, and Lycoris
Linux. It used almost the same motherboard that Roland and I used for
the HSM article. One difference was that it had a floppy port and one
hard drive port. Wish I'd bought ten!

Distributors are having a bitch of a time keeping these things in stock
because with the rather lean Linux distros and open office, they fly for
desktops and surfers. Not even bad for dual boot with MS-95.

Ray

Discussion Thread

krnldmp <krnldmp@y... 2003-01-21 17:57:51 UTC EMC question Tim Goldstein 2003-01-21 18:04:31 UTC RE: [CAD_CAM_EDM_DRO] EMC question krnldmp <krnldmp@y... 2003-01-21 18:21:35 UTC Re: EMC question krnldmp <krnldmp@y... 2003-01-21 18:31:46 UTC Re: EMC question Matt Shaver 2003-01-21 21:45:05 UTC Re: [CAD_CAM_EDM_DRO] EMC question Ray Henry 2003-01-22 06:49:42 UTC Re: Re: EMC question jmkasunich <jmkasunich@y... 2003-01-22 07:11:34 UTC Re: EMC question krnldmp <krnldmp@y... 2003-01-22 08:02:55 UTC Re: EMC question krnldmp <krnldmp@y... 2003-01-22 08:27:15 UTC Re: EMC question Jon Elson 2003-01-22 09:49:40 UTC Re: [CAD_CAM_EDM_DRO] Re: EMC question Ray Henry 2003-01-22 10:28:16 UTC Re: Re: EMC question Ray Henry 2003-01-22 10:43:43 UTC Re: Re: EMC question jmkasunich <jmkasunich@y... 2003-01-22 12:09:17 UTC Re: EMC question j.guenther 2003-01-22 12:18:42 UTC RE: [CAD_CAM_EDM_DRO] Re: EMC question krnldmp <krnldmp@y... 2003-01-22 13:30:51 UTC Re: EMC question