Re: [CAD_CAM_EDM_DRO] Gear cutting
Posted by
Zafar Salam
on 2003-02-03 06:30:48 UTC
Myron,
Search for geargen on simtel.net. With it you can creat dxf files for gear
tooth profiles. I guess it would help.
Regards,
Zafar
Search for geargen on simtel.net. With it you can creat dxf files for gear
tooth profiles. I guess it would help.
Regards,
Zafar
> Sometime ago there were postings about cutting gears (for clocks, Ibelieve)
> but I can't find the thread.
>
> I want to cut 25 teeth with a diametral pitch of 3, approximately 9 inches
> in diameter in steel plate one quarter of an inch thick.
> I can use a 0.25 inch endmill because the radius at the dedendum is one
> eighth of an inch.
>
> Are there any gear cutting programs that I could use?
>
> Thanks in advance for any help.
>
> Myron Cherry
Discussion Thread
Myron Cherry
2003-02-02 22:20:30 UTC
Re: [CAD_CAM_EDM_DRO] Gear cutting
Zafar Salam
2003-02-03 06:30:48 UTC
Re: [CAD_CAM_EDM_DRO] Gear cutting
Randy Gordon-Gilmore
2003-02-03 09:34:03 UTC
Re: [CAD_CAM_EDM_DRO] Gear cutting
Randy Gordon-Gilmore
2003-02-03 10:10:37 UTC
Re: [CAD_CAM_EDM_DRO] Gear cutting
Alan Marconett KM6VV
2003-02-03 10:38:30 UTC
Re: [CAD_CAM_EDM_DRO] Gear cutting