Re: LCD monitor for CNC controller

You can check out this website for mono screens,
http://eio.com/lcdprodt.htm . However, it is still cheaper to get
the whole package, i.e., LCD monitor which u can get for under 200
bucks using a standard VGA card, as the other has mentioned. The
LCD driver card cost around 150.00.

Good luck,
Mac






--- In CAD_CAM_EDM_DRO@yahoogroups.com, "squidsrus85
<squidsrus85@y...>" <squidsrus85@y...> wrote:

> Hi guys,
>
> I have a dos-based control running under win98 using a PCI VGA

color

> monitor. The entire box weighs a ton and most of the weight is in

the

> 15" monitor.
>
> I am sure a 10" - 12" LCD composite mono monitor would be fine as

the

> colors on the current VGA screen don't do anything that matters if
> they were all B&W.
>
> Anyone now where I can get an ISA or PCI LCD for something less

than

> the national debt? I have seen some flat panel displays for around
> $200, but seem to think there must be some older ex-laptop

displays

> out there somewhere in the under-100-buck range.
>
> Any and all suggestions greatly appreciated.