Re: making a digitizer probe
Posted by
Graham Stabler <eexgs@n...
on 2003-02-20 12:43:05 UTC
Thanks for all the descriptions guys.
I did search the archive but the search was as good as usual.
I'm starting to understand, I hadn't realised the probe had to
trigger in all directions,
With the three terminal designs what happens on a steep side, does
the probe tend to slide down the side? How is the z measurement
effected? Ah, but that will rock the probe, got it :)
I have found the pdf with the 3D models in the files section, thanks
again. It looks very doable.
Right, now to find some balls.
Cheers,
Graham
I did search the archive but the search was as good as usual.
I'm starting to understand, I hadn't realised the probe had to
trigger in all directions,
With the three terminal designs what happens on a steep side, does
the probe tend to slide down the side? How is the z measurement
effected? Ah, but that will rock the probe, got it :)
I have found the pdf with the 3D models in the files section, thanks
again. It looks very doable.
Right, now to find some balls.
Cheers,
Graham
Discussion Thread
Graham Stabler <eexgs@n...
2003-02-20 04:15:15 UTC
making a digitizer probe
turbulatordude <davemucha@j...
2003-02-20 05:36:16 UTC
Re: making a digitizer probe
Graham Stabler <eexgs@n...
2003-02-20 05:50:12 UTC
Re: making a digitizer probe
Hoyt McKagen
2003-02-20 07:19:53 UTC
Re: [CAD_CAM_EDM_DRO] Re: making a digitizer probe
ballendo <ballendo@y...
2003-02-20 08:12:40 UTC
Re: making a digitizer probe
Carlos Guillermo
2003-02-20 08:43:56 UTC
RE: [CAD_CAM_EDM_DRO] Re: making a digitizer probe
Alan Marconett KM6VV
2003-02-20 10:53:24 UTC
Re: [CAD_CAM_EDM_DRO] making a digitizer probe
Graham Stabler <eexgs@n...
2003-02-20 12:43:05 UTC
Re: making a digitizer probe
dvideohd <jrobinson46@c...
2003-02-23 16:50:48 UTC
Re: making a digitizer probe