Re: [CAD_CAM_EDM_DRO] Re: making a digitizer probe
Posted by
Hoyt McKagen
on 2003-02-20 07:19:53 UTC
At 01:36 PM 2/20/03 -0000, you wrote:
axis/direction in use. I poll the switch state at each increment of side
motion, step the probe appropriately (first away from part then back to
it), and take coords when it finally closes again.
Regards, Hoyt McKagen
Anti-virus request: Please do not add this email addy to address books
Belfab CNC - http://www.freeyellow.com/members/belfab/belfab.html
US Best MC - http://www.freeyellow.com/members/batwings/best.html
Camping/Caving - http://www.freeyellow.com/members/batwings/caving.html
Q: How many French can successfully defend Paris? A: That's still
undetermined.
>I had envisioned chucking up a piece of steel in a nylon collet andThat's how I do it. The probe uses limit switch input for whatever
>running a wire to the probe. The other end to the part. then
>whenever there is contact, the input changes state.
axis/direction in use. I poll the switch state at each increment of side
motion, step the probe appropriately (first away from part then back to
it), and take coords when it finally closes again.
Regards, Hoyt McKagen
Anti-virus request: Please do not add this email addy to address books
Belfab CNC - http://www.freeyellow.com/members/belfab/belfab.html
US Best MC - http://www.freeyellow.com/members/batwings/best.html
Camping/Caving - http://www.freeyellow.com/members/batwings/caving.html
Q: How many French can successfully defend Paris? A: That's still
undetermined.
Discussion Thread
Graham Stabler <eexgs@n...
2003-02-20 04:15:15 UTC
making a digitizer probe
turbulatordude <davemucha@j...
2003-02-20 05:36:16 UTC
Re: making a digitizer probe
Graham Stabler <eexgs@n...
2003-02-20 05:50:12 UTC
Re: making a digitizer probe
Hoyt McKagen
2003-02-20 07:19:53 UTC
Re: [CAD_CAM_EDM_DRO] Re: making a digitizer probe
ballendo <ballendo@y...
2003-02-20 08:12:40 UTC
Re: making a digitizer probe
Carlos Guillermo
2003-02-20 08:43:56 UTC
RE: [CAD_CAM_EDM_DRO] Re: making a digitizer probe
Alan Marconett KM6VV
2003-02-20 10:53:24 UTC
Re: [CAD_CAM_EDM_DRO] making a digitizer probe
Graham Stabler <eexgs@n...
2003-02-20 12:43:05 UTC
Re: making a digitizer probe
dvideohd <jrobinson46@c...
2003-02-23 16:50:48 UTC
Re: making a digitizer probe