Re: Feedback on Free stepper calculator

--- In CAD_CAM_EDM_DRO@yahoogroups.com, Larry Van Duyn
<lvanduyn@z...> wrote:

> FSivc> http://www.imsrv.com/fredcalc.zip
>
> I tried it with the numbers for the plasma table I am putting
> together. It has 24 pitch rack, 15 tooth pinon, 55/14 belt
> reduction and a servo motor with 250 line (1000 count) encoder.
> The numbers on the program are correct but when I copy to
> clipboard, the numbers don't match what is on the program.

Thanks Larry. I noticed a problem too when I tested with your
numbers. I then switched to Direct drive and the calculations were
correct, but the paste was off by a factor of 10, then back to the
belt reduction and the numbers came out correct. I am guessing that
it is a sequencing/flushing problem with the copy. I'll report it.

Still no joy here on the drip feed for the AB8400. :-(

Best Regards,

Fred Smith - IMService