CAD CAM EDM DRO - Yahoo Group Archive

Re: Inexpensive oscilloscope?

Posted by tony@j...
on 2003-03-07 22:54:29 UTC
Jon Elson writes:

>
>
> Monte Westlund wrote:
>
> >Would one of these work for testing/tuning Gecko 320 drivers? They
> >look to have output to a computer such as a real oscilloscope does.
> >A couple down at the bottom of this page:
> >http://www.electronic-supply.com/DMM-page.htm
> >
> >
> Probably not. I think this is a long-term data logging function, and
> can only get
> one or two data points a second, at the most.
>

You might consider one of the PC-based 'scopes from these guys though:

http://www.picotech.com/

I have one of their ADC 200 units & have found it very useful indeed. They
also do a much cheaper unit called "DrDAQ" (http://www.drdaq.com/) that is
capable of use as an oscilloscope for low frequency waveforms (i.e., of the
order of 10K Hz and below).

Regards,
Tony

Discussion Thread

Monte Westlund 2003-03-07 20:25:20 UTC Inexpensive oscilloscope? Jon Elson 2003-03-07 22:23:57 UTC Re: [CAD_CAM_EDM_DRO] Inexpensive oscilloscope? tony@j... 2003-03-07 22:54:29 UTC Re: Inexpensive oscilloscope? Monte Westlund 2003-03-07 23:04:25 UTC Re: Inexpensive oscilloscope? tony@j... 2003-03-07 23:07:48 UTC Re: Inexpensive oscilloscope? Keith Bowers 2003-03-08 13:07:08 UTC Re: [CAD_CAM_EDM_DRO] Re: Inexpensive oscilloscope? Dan Mauch 2003-03-08 13:43:42 UTC RE: [CAD_CAM_EDM_DRO] Inexpensive oscilloscope? halle@t... 2003-03-08 13:53:48 UTC Re: [CAD_CAM_EDM_DRO] Inexpensive oscilloscope?