Re: GCode Optimizer?

--- In CAD_CAM_EDM_DRO@yahoogroups.com, "caudlet" <info@t...> wrote:

> I am doing basic design in Corel (vector graphics) then using an
> older version of ArtCam to generate the gcode. I avoid DXF if
> possible since it will not export bezier curves/arcs except as a
> series of small line segments. My gcode files are all setup so each
> tool size has a different cut file so an optimize at the g-code

level

> would be great since it would optimize the cuts for each tool.
>

Backplot the tool specific G-code into VectorCam, Remove the Z
connections (a box selection from the front or side view).

Next select the start contour and then the rest with pick and match,
reorganize the cuts, then re-connect at Z.

Any of the cheap simulators will show the resulting cuts before you
commit to material. I like MetacutView for mill and CNCezpro for
Mill and Lathe.

Best Regards, Fred Smith- IMService

Listserve Special discounts and offers are at:
http://www.imsrv.com/hobby/grp.html

We are THE source for low cost Cad Cam