RE: [CAD_CAM_EDM_DRO] Re: Stepper Motor Travel?

Gecko 201 are 10 micro step controllers. They break each normal motor
step into 10 steps. So if you have 200 step/rev motors (most likely)
with a G201 you will need to give it 2000 step pulses to make one
revolution. With a 20 tpi direct drive screw that gives you 40000 steps
per inch.

Tim
[Denver, CO]
Sherline products at Deep Discount
Mach1 & DeskCNC with credit card ordering
www.KTMarketing.com/Sherline
Now selling Visual Mill

> -----Original Message-----
> Tim, I think your on to something. Gecko 201's are what I'm using.
> That would make sense but I guess I need to read the manual again.
> Must have overlooked that if correct.
>
> Barclay
> FAQ: http://www.ktmarketing.com/faq.html