G320 Rev2
Posted by
jeffdavis516
on 2003-04-09 13:13:27 UTC
I just finished my second servo controller box. The first thing I
noticed when I powered them up was the fact I did not have to hold
the engage switch for 5 seconds to power them up. They came up right
away when the switch was activated. Does anyone know what other
changes these new G320's have from the first set Mariss was selling?
Jeff Davis
http://www.homecnc.info
noticed when I powered them up was the fact I did not have to hold
the engage switch for 5 seconds to power them up. They came up right
away when the switch was activated. Does anyone know what other
changes these new G320's have from the first set Mariss was selling?
Jeff Davis
http://www.homecnc.info