Re: [CAD_CAM_EDM_DRO] laplink cable

I cut an old Laplink cable. I new it would come in handy for something
someday. This is one of the kind with a 25 pin connector at each end not
the 9 and 25 pin combination at each end. There are 15 conductors in mine
so obviuosly 10 of the pins are either dead or share a wire. Hope this
helps. What are you trying to do? If you are trying to go from your
parallel port to a controller go to Radio Shack and get some 25 conductor
ribbon cable and some connectors and "roll your own".

JIm