CAD CAM EDM DRO - Yahoo Group Archive

Re: testing with multi-meter

Posted by andrewyslee
on 2003-04-20 15:31:29 UTC
"andrewyslee" <andrewlee@s...> wrote:
> Is it safe to connect a multimeter to the phase A/phase B of the
> motor cables, set to measure current/voltage. If it is what would I
> expect to read?

Digital multimeter max. Amp is only 200mA.

Set to read DC Volt and connected to 1 phase. Reading was 0.000 when
power off. The moment driver is powered on the Reading changed to 1
(meaning no reading I think) What does this mean?

Andrew

Discussion Thread

andrewyslee 2003-04-19 01:34:45 UTC testing with multi-meter caudlet 2003-04-19 09:16:04 UTC Re: testing with multi-meter andrewyslee 2003-04-20 06:13:14 UTC Re: testing with multi-meter turbulatordude 2003-04-20 08:25:24 UTC Re: testing with multi-meter - GECKO andrewyslee 2003-04-20 13:22:51 UTC Re: testing with multi-meter - GECKO andrewyslee 2003-04-20 13:30:54 UTC Re: testing with multi-meter - GECKO andrewyslee 2003-04-20 15:31:29 UTC Re: testing with multi-meter turbulatordude 2003-04-20 20:07:57 UTC Re: testing with multi-meter - GECKO (oh Mariss....) Harvey White 2003-04-21 08:18:22 UTC Re: [CAD_CAM_EDM_DRO] Re: testing with multi-meter Harvey White 2003-04-21 08:18:28 UTC Re: [CAD_CAM_EDM_DRO] Re: testing with multi-meter - GECKO andrewyslee 2003-04-21 09:00:15 UTC Re: testing with multi-meter - GECKO Jon Elson 2003-04-21 22:39:03 UTC Re: [CAD_CAM_EDM_DRO] Re: testing with multi-meter - GECKO andrewyslee 2003-04-21 23:03:22 UTC Re: testing with multi-meter - GECKO Jon Elson 2003-04-22 09:29:03 UTC Re: [CAD_CAM_EDM_DRO] Re: testing with multi-meter - GECKO