Re: [CAD_CAM_EDM_DRO] Re: High Speed Machining Look ahead EMC

Bob Simon wrote:

>>>Some external control via the .ini file of interpolation control
>>>points and basis functions would be nice. In other words have the
>>>option of controlling the smoothness parameters- and perhaps not
>>>
>>>
>>smooth
>>
>>
>>>certain hard corners beyond a certain trajectory change angle. It
>>>
>>>
>>would
>>
>>
>>>be nice.
>>>
>>>

EMC does have G-codes that select between smoothing and exact stop mode.
It would be nice to
have some finer adjustment than these two extremes, and be a lot better
if it was available by
G-code, to select block by block what sort of smoothing is needed.

Jon