Re: [CAD_CAM_EDM_DRO] Re: High Speed Machining Look ahead EMC

When I went through the Lincoln Electric Robotic Welding School, the FANUC
Program/Controller used on the Robots allowed a 'scaling factor' for
movement (deceleration/acceleration) into and out of corners. You could
actually specify a number that would relate to the 'sharpness' of the
corner. Could EMC be 'tweaked' to accomplish something like that?

RayHex
----------

> Big Snip

> EMC does have G-codes that select between smoothing and exact stop mode.
> It would be nice to
> have some finer adjustment than these two extremes, and be a lot better
> if it was available by
> G-code, to select block by block what sort of smoothing is needed.