fun with moglice
Posted by
cadcamclub
on 2003-05-14 18:52:07 UTC
http://photos.groups.yahoo.com/group/cad_cam_edm_dro/lst?.dir=/Fun+wit
h+Moglice&.src=gr&.view=
Nice way to construct drive nuts!!!!
Are those moglice drive nuts still giving good service?
If I drill 2 perpendicular holes in a block of aluminium, then a
pocket in the middle of the block, then purchase 2 threaded rod from
the hardware store, spray release agents onto the threaded rods, then
put them into the drilled holed, then plug up the holes, then pour
moglice into the pocket, will I have a serviceable saddle that I can
use with stainless steel guide rods purchased from the hardware store?
Perhaps I can also cast serviceable bearings/bushes for those guide
rods with moglice?
Comments please and thanks
Al
h+Moglice&.src=gr&.view=
Nice way to construct drive nuts!!!!
Are those moglice drive nuts still giving good service?
If I drill 2 perpendicular holes in a block of aluminium, then a
pocket in the middle of the block, then purchase 2 threaded rod from
the hardware store, spray release agents onto the threaded rods, then
put them into the drilled holed, then plug up the holes, then pour
moglice into the pocket, will I have a serviceable saddle that I can
use with stainless steel guide rods purchased from the hardware store?
Perhaps I can also cast serviceable bearings/bushes for those guide
rods with moglice?
Comments please and thanks
Al
Discussion Thread
cadcamclub
2003-05-14 18:52:07 UTC
fun with moglice
cadcamclub
2003-05-14 19:04:33 UTC
Re: fun with moglice
turbulatordude
2003-05-15 05:39:08 UTC
Re: fun with moglice
doug98105
2003-05-15 06:10:40 UTC
Re: fun with moglice