Re: CNC Lathe Attachment

"onecooltoolfool" <joevicar3@i...> wrote:

> > See photos in the "files" section under "CNC LATHE ATTACHMENT"
> >folder.

Photos in files section? Went off on a wild goose chase until I
finally wised up and reread the message.

That attachment looks like an additional x-axis mounted parallel to
the original x-axis? Is that a rotary "something" on the "saddle" to
allow the new "x-axis" to rotate to an angle to the original x-axis
for taper turning or something?

Hope for some explaination for non-machinist on what this attachment
all about.

Thanks

Al