Re: [CAD_CAM_EDM_DRO] FlashcurCNC and close loop
Posted by
David A. Frantz
on 2003-05-22 17:46:49 UTC
Hi George;
Encoders or not I have a hard time think of steppers as a closed loop
solution. I geuss it is a matter of how much resolution you need, I
just have a hardtime imagining a stepper servoing to withing a couple of
encoder counts under full load.
Dave
george_barr wrote:
Encoders or not I have a hard time think of steppers as a closed loop
solution. I geuss it is a matter of how much resolution you need, I
just have a hardtime imagining a stepper servoing to withing a couple of
encoder counts under full load.
Dave
george_barr wrote:
>I want to put together a "closed loop" cnc system. I have Gecko
>drives G201 and stepper motors with encoders. I am considering the
>FlashCutCNC 401A system which is a software and signal generator.
>Will the above setup be enough and integrate well together to provide
>a "close loop" cnc system? Right now, minitech at
>http://www.minitech.com/software/flashcut/flashcut_info.htm
>is offering the FlashCutCNC 401A for $800 on sale, normally $1100.
>This is almost 30% off. But before buying it, I want to know if it
>will fit my "close loop" needs. CamsoftCorp at
>http://camsoftcorp.com/ is too expensive for "close loop" operation.
>
>Thanks,
>
>
>
>Addresses:
>FAQ: http://www.ktmarketing.com/faq.html
>FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>Post Messages: CAD_CAM_EDM_DRO@yahoogroups.com
>
>Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
>Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
>List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@..., timg@...
>Moderator: pentam@... indigo_red@... [Moderators]
>URL to this group: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
>
>OFF Topic POSTS: General Machining
>If you wish to post on unlimited OT subjects goto: aol://5863:126/rec.crafts.metalworking or go thru Google.com to reach it if you have trouble.
>http://www.metalworking.com/news_servers.html
>
>http://groups.yahoo.com/group/jobshophomeshop I consider this to be a sister site to the CCED group, as many of the same members are there, for OT subjects, that are not allowed on the CCED list.
>
>NOTICE: ALL POSTINGS TO THIS GROUP BECOME PUBLIC DOMAIN BY POSTING THEM. DON'T POST IF YOU CAN NOT ACCEPT THIS.....NO EXCEPTIONS........
>bill
>List Mom
>List Owner
>
>
>
>Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>
>
>
>
>
Discussion Thread
george_barr
2003-05-22 09:38:34 UTC
FlashcurCNC and close loop
David A. Frantz
2003-05-22 17:46:49 UTC
Re: [CAD_CAM_EDM_DRO] FlashcurCNC and close loop
Chris L
2003-05-22 19:16:15 UTC
Re: [CAD_CAM_EDM_DRO] FlashcurCNC and close loop