Re: [CAD_CAM_EDM_DRO] Servo-DRO advice sought
Posted by
Chris Baugher
on 2003-06-03 16:29:29 UTC
On Tue, 3 Jun 2003, Jon Elson wrote:
It's still too slow for much speed though, maybe 3 inches/minute. It
might be made to work if the controller knew where it's final position
should be (translate: understands G-code), then it could change the speed
of movement depending on how far it has left to go. Still not an easy
task.
C|
> >The encoder would be a digital dro ( the ones that are similar toJust a note, the imported scales can be set to update 50 times/second.
> >digital calipers but with mounting brackets) with an io connector.
> >(Any other idears welcome!)
>
> These units only update 2-4 times a second. That would allow precise
> movement of about 10 inches/hour.
It's still too slow for much speed though, maybe 3 inches/minute. It
might be made to work if the controller knew where it's final position
should be (translate: understands G-code), then it could change the speed
of movement depending on how far it has left to go. Still not an easy
task.
> >Could this work?Or at least very difficult and probably not worth the effort.
> >
> No, it will be a total disaster.
C|
Discussion Thread
paragon032003
2003-06-03 09:08:31 UTC
Servo-DRO advice sought
Jon Elson
2003-06-03 09:58:31 UTC
Re: [CAD_CAM_EDM_DRO] Servo-DRO advice sought
Chris Baugher
2003-06-03 16:29:29 UTC
Re: [CAD_CAM_EDM_DRO] Servo-DRO advice sought
Weyland
2003-06-03 20:19:04 UTC
Greetings all over again~!
s g
2003-06-04 10:25:42 UTC
Re: [CAD_CAM_EDM_DRO] Servo-DRO advice sought
Larry Ragan
2003-06-04 11:40:55 UTC
RE: [CAD_CAM_EDM_DRO] Servo-DRO advice sought