Re: [CAD_CAM_EDM_DRO] Dan's product announcement
Posted by
Dan Mauch
on 2000-03-11 06:15:30 UTC
Ok I look at adding them.
Dan
-----Original Message-----
From: wanliker@... <wanliker@...>
To: CAD_CAM_EDM_DRO@onelist.com <CAD_CAM_EDM_DRO@onelist.com>
Date: Friday, March 10, 2000 2:15 PM
Subject: Re: [CAD_CAM_EDM_DRO] Dan's product announcement
Dan
-----Original Message-----
From: wanliker@... <wanliker@...>
To: CAD_CAM_EDM_DRO@onelist.com <CAD_CAM_EDM_DRO@onelist.com>
Date: Friday, March 10, 2000 2:15 PM
Subject: Re: [CAD_CAM_EDM_DRO] Dan's product announcement
>From: wanliker@...until
>
>In a message dated 3/10/00 1:51:22 PM Mountain Standard Time,
>dmauch@... writes:
>
><< Flip the direction switch and the manual
> direction would flip.
> I'll see if I can draw it up soon.
> Dan >>
>Dan, when you draw it up, any chance you can add limit switches, into the
>circuit?
>This would make it easier for those that are using it as a power feed,
>they take the next step to CAM.
>Thanks,
>bill
>
Discussion Thread
Dan Mauch
2000-03-10 12:51:51 UTC
Re: [CAD_CAM_EDM_DRO] Dan's product announcement
Marshall Pharoah
2000-03-10 13:07:29 UTC
Re: [CAD_CAM_EDM_DRO] Dan's product announcement
wanliker@a...
2000-03-10 14:16:43 UTC
Re: [CAD_CAM_EDM_DRO] Dan's product announcement
Tim Goldstein
2000-03-10 14:30:47 UTC
Re: [CAD_CAM_EDM_DRO] Dan's product announcement
Dan Mauch
2000-03-11 06:09:39 UTC
Re: [CAD_CAM_EDM_DRO] Dan's product announcement
Dan Mauch
2000-03-11 06:15:30 UTC
Re: [CAD_CAM_EDM_DRO] Dan's product announcement