RE: [CAD_CAM_EDM_DRO] re-selection of motors....avoiding another rathole
Posted by
Tim Goldstein
on 2003-06-13 21:25:40 UTC
A frequent problem with gearhead motors it backlash in the geartrain.
There are zero backlash gearheads, but they are pricey and not very
common. Belt reduction is low cost and proven. Follow what is known to
work and you will avoid another rathole.
Tim
[Denver, CO]
Sherline products at Deep Discount
Mach1 & DeskCNC with credit card ordering
www.KTMarketing.com/Sherline
There are zero backlash gearheads, but they are pricey and not very
common. Belt reduction is low cost and proven. Follow what is known to
work and you will avoid another rathole.
Tim
[Denver, CO]
Sherline products at Deep Discount
Mach1 & DeskCNC with credit card ordering
www.KTMarketing.com/Sherline
Discussion Thread
etauch
2003-06-13 19:56:23 UTC
re-selection of motors....avoiding another rathole
Carlos Guillermo
2003-06-13 20:20:38 UTC
RE: [CAD_CAM_EDM_DRO] re-selection of motors....avoiding another rathole
Tim Goldstein
2003-06-13 21:25:40 UTC
RE: [CAD_CAM_EDM_DRO] re-selection of motors....avoiding another rathole
Jon Elson
2003-06-13 22:00:25 UTC
Re: [CAD_CAM_EDM_DRO] re-selection of motors....avoiding another rathole
etauch
2003-06-13 23:21:40 UTC
Re: re-selection of motors....avoiding another rathole
David A. Frantz
2003-06-14 00:02:29 UTC
Re: [CAD_CAM_EDM_DRO] re-selection of motors....avoiding another rathole
turbulatordude
2003-06-14 06:13:15 UTC
Re: re-selection of motors....avoiding another rathole - question ?
mmurray701
2003-06-14 06:32:48 UTC
Re: re-selection of motors....avoiding another rathole
Jon Elson
2003-06-14 23:18:38 UTC
Re: [CAD_CAM_EDM_DRO] Re: re-selection of motors....avoiding another rathole - question ?
bob_quale
2003-06-15 23:30:39 UTC
Rutex servo drivers compared to servos to go?
Jon Elson
2003-06-16 10:13:15 UTC
Re: [CAD_CAM_EDM_DRO] Rutex servo drivers compared to servos to go?
caudlet
2003-06-16 11:24:23 UTC
Re: Rutex servo drivers compared to servos to go?
Quale, Robert
2003-06-16 21:26:34 UTC
RE: [CAD_CAM_EDM_DRO] Re: Rutex servo drivers compared to servos to go?
Jon Elson
2003-06-16 22:17:26 UTC
Re: [CAD_CAM_EDM_DRO] Re: Rutex servo drivers compared to servos to go?
Jon Elson
2003-06-16 22:30:31 UTC
Re: [CAD_CAM_EDM_DRO] Re: Rutex servo drivers compared to servos to go?