CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Re: handwheel dials and ballscrew diameters

Posted by Weyland
on 2003-07-08 18:46:47 UTC
On Tuesday 08 July 2003 07:19 pm, mayfieldtm spake:

> I have the Model 1006 with a 9x32" table and
> about 7x24" travel.
> In "Home Shop Machinist", Roland Friestad wrote
> a series of articles on converting these type
> Mills. (That was the first half of 2002)
> If you get a chance, look them over.
> Very well done.
> Tom M.

Thanks~!

Weyland

Discussion Thread

Weyland 2003-07-07 12:56:12 UTC handwheel dials and ballscrew diameters JanRwl@A... 2003-07-07 13:18:03 UTC Re: [CAD_CAM_EDM_DRO] handwheel dials and ballscrew diameters ccq@x... 2003-07-07 18:52:45 UTC Re: [CAD_CAM_EDM_DRO] handwheel dials and ballscrew diameters Weyland 2003-07-07 19:38:15 UTC Re: [CAD_CAM_EDM_DRO] handwheel dials and ballscrew diameters Weyland 2003-07-07 19:42:38 UTC Re: [CAD_CAM_EDM_DRO] handwheel dials and ballscrew diameters mayfieldtm 2003-07-08 07:53:55 UTC Re: handwheel dials and ballscrew diameters Weyland 2003-07-08 14:06:09 UTC Re: [CAD_CAM_EDM_DRO] Re: handwheel dials and ballscrew diameters mayfieldtm 2003-07-08 16:19:56 UTC Re: handwheel dials and ballscrew diameters Weyland 2003-07-08 18:46:47 UTC Re: [CAD_CAM_EDM_DRO] Re: handwheel dials and ballscrew diameters