Re: Relay to operate soliniod or other idea?
Posted by
ron_routledge
on 2003-07-13 17:55:42 UTC
Hi,
I use CNCPRO on my plasma table. To turn the torch on and off I
have a breakout board from Axxus driving a relay. The relay is just
a simple 5 wire (N.O. or N.C.) one that can be picked up at any
autoparts place (I buy mine from the local Freightliner dealer).
The breakout board takes care of all of the electronics and simply
gives you two terminals to attach to the coil of the relay. orks
like a charm.
Ron Routledge
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "shelbyshepherd2002"
<cabrillo_shepherd@m...> wrote:
I use CNCPRO on my plasma table. To turn the torch on and off I
have a breakout board from Axxus driving a relay. The relay is just
a simple 5 wire (N.O. or N.C.) one that can be picked up at any
autoparts place (I buy mine from the local Freightliner dealer).
The breakout board takes care of all of the electronics and simply
gives you two terminals to attach to the coil of the relay. orks
like a charm.
Ron Routledge
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "shelbyshepherd2002"
<cabrillo_shepherd@m...> wrote:
> I am using Yeager CNCPRO to contol an X Y table. Can someonesuggest
> the solution to trigger an electric solinoid (12 or 24 volt)switch
> for an air ram?
> The table will move 50 mm then stops and the ram activates, this
> process goes for 30 times and then back to the start.
> If a relay is used what type is needed to suit and how is it wired
> into the system?
> If someone out there has a better idea, I would like to know there
> thoughts.
>
> Thanks
> Shelby
Discussion Thread
shelbyshepherd2002
2003-07-11 16:32:17 UTC
Relay to operate soliniod or other idea?
JanRwl@A...
2003-07-11 16:55:48 UTC
Re: [CAD_CAM_EDM_DRO] Relay to operate soliniod or other idea?
shelbyshepherd2002
2003-07-11 21:50:21 UTC
Re: Relay to operate soliniod or other idea?
Jon Elson
2003-07-11 23:59:30 UTC
Re: [CAD_CAM_EDM_DRO] Relay to operate soliniod or other idea?
JanRwl@A...
2003-07-12 14:20:09 UTC
Re: [CAD_CAM_EDM_DRO] Re: Relay to operate soliniod or other idea?
shelbyshepherd2002
2003-07-12 18:11:33 UTC
Re: Relay to operate soliniod or other idea?
ron_routledge
2003-07-13 17:55:42 UTC
Re: Relay to operate soliniod or other idea?
turbulatordude
2003-07-13 18:35:32 UTC
Re: Relay to operate soliniod or other idea?