Re: [CAD_CAM_EDM_DRO] how to build a mini mill???

On Sat, 26 Jul 2003 13:02:01 -0400, you wrote:

<snip>

>Simonho: I've a reprint from Nuts & Volts dated Jan '99 which means the
>original was published before that. It's titled CCNC a series of CNC
>shop equipment built on the cheap. I can say that mechanically they work
>fine. Unfortunately the electronics are beyond my abilities. The author
>of the series was a Dan Mauch. I hope he is still contributing to the
>public and that I can eventually ask him a couple questions. The
>articles are specific enough to build either the drill press, the mill,
>or the saw, the wire cutter required a little imagination. I've been able
>to build working, manual versions as proof of concepts. A-OK!

Wire cutter?

I do wirewrap, an automated wire cutter would be an interesting
project.

Is that what you are talking about?

Harvey


>
>I don't have access to the WEB, so I can't say for sure that their site
>will help you any, but, www.nutsvolts.com is the place to start. Dan
>relied on some shareware as a cornerstone and I don't know if it's still
>available. I haven't seen it mentioned here since I've followed( at a
>distance) this group.
>
>Good luck, Nick
>