CAD CAM EDM DRO - Yahoo Group Archive

Re: How to you make a 1/8" collet on a 1/4" shaft

Posted by dodge1320
on 2003-07-30 17:15:08 UTC
>
> Any thoughts or better yet can someone make me the part I seek?
> Dean


Hi Dean. Check out the photos section, Rick-o-matic folder. I added
a picture of a spindle arrangement I made (too slow and under
powered). It is a piece of round stock that I drilled and reamed out
to .250 for the motor and then drilled and reamed (.375?) and
chamfered 30 degrees for a DA-100 size collet. Threaded the outside
for the collet thread (??). All of this was done at the same time
while in a lathe. Put in 3 10/32 tapped holes (120 degrees apart)
for "fine tuning". Used a factory nut and collet. Indicated it in
within 2 tenths. sounds harder to make than it really was! Contact
me offline (as we are almost off topic) if you have any other
questions! Rick Rchownyk@(the aol place).com

Discussion Thread

deansala 2003-07-30 11:29:03 UTC How to you make a 1/8" collet on a 1/4" shaft doug98105 2003-07-30 12:57:48 UTC Re: How to you make a 1/8" collet on a 1/4" shaft turbulatordude 2003-07-30 13:23:37 UTC Re: How to you make a 1/8" collet on a 1/4" shaft mayfieldtm 2003-07-30 13:52:49 UTC Re: How to you make a 1/8" collet on a 1/4" shaft deansala 2003-07-30 13:55:20 UTC Re: How to you make a 1/8" collet on a 1/4" shaft Carl Mikkelsen 2003-07-30 14:34:53 UTC Re: [CAD_CAM_EDM_DRO] How to you make a 1/8" collet on a 1/4" shaft turbulatordude 2003-07-30 15:28:27 UTC Re: How to you make a 1/8" collet on a 1/4" shaft turbulatordude 2003-07-30 15:29:58 UTC Re: How to you make a 1/8" collet on a 1/4" shaft Harvey White 2003-07-30 16:12:22 UTC Re: [CAD_CAM_EDM_DRO] Re: How to you make a 1/8" collet on a 1/4" shaft dodge1320 2003-07-30 17:15:08 UTC Re: How to you make a 1/8" collet on a 1/4" shaft glee@i... 2003-07-30 18:39:25 UTC [CAD_CAM_EDM_DRO] I looked into another EDM Software design program turbulatordude 2003-07-30 20:51:07 UTC Re: I looked into another EDM Software design program Denis Casserly 2003-07-31 12:24:47 UTC Re: [CAD_CAM_EDM_DRO] How to you make a 1/8" collet on a 1/4" shaft